Check out the Recovery Procedure for exact details about this. At this stage, if the Player detects a USB flash drive connected to the zip file with the software image inside, it will re-write the whole software from scratch on the SD card. If your RPi 4 players are stuck at this screen for more than 1 minute, make sure that you are using the correct HDMI port on your Raspberry Pi 4, as shown in the image below:Īfter the previous stage, a “ Searching for USB drives…” text message should appear in the screen’s top-left corner. Yodeck player based on the Raspberry Pi 4 The screen is correctly connected to the Player, and colors appear normal.The booting stage works, and the next stage will ( probably) work.The Player is powered adequately, with enough power for this stage.The SD card is plugged in correctly and read by the Player.This indicates that the CPU has loaded the firmware and will begin booting immediately.īy confirming that this screen is shown on boot, you confirm that: The first picture on the screen is a multi-colored rectangular test image shown for just 2 seconds. The delay allows the screen to “ boot” first so that the Player can then detect the screen’s resolution. This allows the Player to auto-detect the connected screen if a power failure affects all equipment. During this stage, nothing is shown on screen. Boot Sequence Stage 1 – Chip Booting Īs soon as you power up the Player, there is a 3-second delay because of booting. This detailed troubleshooting guide focuses on the most common problems customers report. The video is being cut off at the edges.The video seems a Bit Blocky/ Pixelated.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |